Change font size
It is currently Sat Oct 20, 2018 5:45 am


Post a new topicPost a reply Page 1 of 1   [ 4 posts ]
Author Message
 Post subject: 1800e Crossmember needed
PostPosted: Sun Jul 30, 2017 9:15 am 
Bone stock

Joined: Sat Nov 14, 2015 1:53 pm
Posts: 19
Hi, have a very soft spot on the bottom of the crossmember. Need a good replacement, or a quality welder to repair.

Any suggestions?

TIA


Top
 Profile  
 
 Post subject: Re: 1800e Crossmember needed
PostPosted: Sun Jul 30, 2017 10:21 pm 
Haha, I just built a W24 Octo-Turbo, now what?!
User avatar

Joined: Wed Jun 14, 2006 4:19 pm
Posts: 2999
Location: Lethbridge, AB
Pictures? Where are you located?

_________________
Coburn Performance - OCD comes naturally.


Top
 Profile  
 
 Post subject: Re: 1800e Crossmember needed
PostPosted: Thu Aug 03, 2017 2:24 pm 
Bone stock

Joined: Sat Nov 14, 2015 1:53 pm
Posts: 19
Hi, thanks for asking. I'm Calgary based but not near the car right now. I'll get a picture next week. It's basically rusted through around the drain hole, about 3" x 10", right where you might put a floor jack. The vertical flanges up the front and back sides appear to be solid.


Top
 Profile  
 
 Post subject: Re: 1800e Crossmember needed
PostPosted: Sat Oct 21, 2017 12:45 pm 
Bone stock

Joined: Sat Nov 14, 2015 1:53 pm
Posts: 19
Hi, after some delay(life gets in the way) here’s a picture. Cutting out the rot and welding a new bottom on it seems to be the simplest cure.

Any suggestions, comments welcome.

Thanks.


You do not have the required permissions to view the files attached to this post.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 1   [ 4 posts ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
610nm Style by Daniel St. Jules of Gamexe.net