Some more fabrication on the Canuck. This week I built the fender covers so that my wiring and stuff say hidden from view. I decided to go with a smooth theme and turned my first cones on the slip roll. They turned out very nice.




Then it was on to the fitting up of other parts. Here's my first attempt at fitting in my new rad...unfortunately the rad builder didn't read my blueprint correctly and got the tabs on the wrong way around . Par for the course on this car really. The back edge of the tab is in the perfect position.





I'm going to try to at least get the entire engine compartment primed by Sunday - paint next week. No need to rush at this point.