Anyone have experience working with the plastic headlight buckets from Olaf? I can't get the trim rings over them on my 220.

Advice appreciated.

btw: With surprisingly-little bending - and no paint - I got the front fender and headlight ring to fit. (This is a thread "un-jacking" , as I think I was frustrated last week, and spewed-out on Dale's thread that I thought the front fender was going to have to be re-done). Or did I just jack my own thread??

Thanks

No experience here...I think everyone is running the steel buckets.

Is there a trick to putting the covers over them then? I've done it before, so can't imagine I'm missing something obvious, but you never know.

I'm down to chrome and electrical (and a leaky brake) then off the jacks!